[OpenSCAD] OpenSCAD Digest, Vol 2, Issue 18

trumpetto trumpetto at gmail.com
Mon Jan 18 13:57:32 CET 2010


> you can either set the number of faces directly by doing this:
>
> $fn=100;
> cylinder(h = 10, r = 20, center = true);
>
> or more elegant:
> cylinder(h = 10, r = 20, center = true, $fn=100);
>
> or you can use the combination of $fs and $fa ($fs is in mm and $fa in
> degrees):
>
> $fs=0.5;
> $fa=5;
> cylinder(h = 10, r = 20, center = true);
>
> greetings
> Philipp
>
> Thanks very much Philipp!
This works fine for me.

My result follows soon.

Trumpetto
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://rocklinux.net/pipermail/openscad/attachments/20100118/c81ff844/attachment.html


More information about the Openscad mailing list