[OpenSCAD] 3D Text

Tony Buser tbuser at gmail.com
Sat Mar 20 18:57:59 CET 2010


On Sat, Mar 20, 2010 at 10:18 AM, Marius Kintel <marius at kintel.net> wrote:
> OpenSCAD is a pit picky when it comes to topology. The resulting topology must be manifold. One example of a non-manifold mesh is when one edge is shared between more than two faces. This happens e.g. in the middle of your '0' character.

Ah you're right, the problem was the 0 character.  Thanks, I think I
can work around that.


More information about the Openscad mailing list