[OpenSCAD] Next Questions
cefiar at gmail.com
Thu May 3 09:11:22 CEST 2012
This is part of the slicing software (Skeinforge, Slic3r).
It is not mandated in the model of the object (STL) per se, so doesn't fall
in the domain of OpenSCAD.
On May 3, 2012 4:24 PM, "M W" <rd232d at yahoo.com> wrote:
> I've seen that various parts built have hexagonal "honeycomb" air spaces
> added inside, to save filament; If needed for a part like a servo mount, is
> there a way to disable this, or enable it for a part you want lighter?
> Also, can you make a hings from thinning an ABS piece down, and if so, how
> thin / how durable is it? (I could always make a place for metal axle pins
> etc. if needed, just curious on this one.)
> Thanks again,
> OpenSCAD mailing list
> OpenSCAD at rocklinux.org
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the OpenSCAD